Scrigroup - Documente si articole

Username / Parola inexistente      

Home Documente Upload Resurse Alte limbi doc  


AccessAdobe photoshopAlgoritmiAutocadBaze de dateCC sharp
CalculatoareCorel drawDot netExcelFox proFrontpageHardware
HtmlInternetJavaLinuxMatlabMs dosPascal
PhpPower pointRetele calculatoareSqlTutorialsWebdesignWindows
WordXml

AspAutocadCDot netExcelFox proHtmlJava
LinuxMathcadPhotoshopPhpSqlVisual studioWindowsXml

gated linux command

linux

+ Font mai mare | - Font mai mic



DOCUMENTE SIMILARE

Trimite pe Messenger
who linux command
gated linux command
finger linux command
rmail linux command
ps linux command
mkfs linux command
strace linux command
colrm linux command
rm linux command
as linux command


gated

gated [options]




TCP/IP command. Gateway routing daemon. gated handles multiple routing protocols and replaces routed and any routing daemons that speak the Hello, EGP, or BGP routing protocols. gated currently handles the RIP, BGP, EGP, Hello, and OSPF routing protocols and can be configured to perform all or any combination of the five.

Options

-c

Parse configuration file for syntax errors, then exit gated, leaving a dump file in /usr/tmp/gated_dump.

-f config_file

Use alternate configuration file, config_file. Default is /etc/gated.conf.

-n

Do not modify kernel's routing table.

-t [trace_options]

Start gated with the specified tracing options enabled. If no flags are specified, assume general. The trace flags are:

adv

Management of policy blocks.

all

Includes normal, policy, route, state, task, and timer.

general

Includes normal and route.

iflist

The kernel interface list.



normal

Normal protocols instances.

parse

Lexical analyzer and parser.

policy

Instances in which policy is applied to imported and exported routes.

route

Any changes to routing table.

state

State machine transitions.

symbols

Symbols read from kernel -- note that they are read before the configuration file is parsed, so this option must be specified on the command line.

task

System tasks and interfaces.

timer

Timer usage.

-C

Parse configuration file for errors and set exit code to indicate if there were any (1) or not (0), then exit.

-N

Do not daemonize.






Politica de confidentialitate



DISTRIBUIE DOCUMENTUL

Comentarii


Vizualizari: 302
Importanta: rank

Comenteaza documentul:

Te rugam sa te autentifici sau sa iti faci cont pentru a putea comenta

Creaza cont nou

Termeni si conditii de utilizare | Contact
© SCRIGROUP 2022 . All rights reserved

Distribuie URL

Adauga cod HTML in site